Padded Fast Clamps – For Fans, Filters and Silencers

Vibration-damping duct joins that stay put all grow

Cable ties and tape slip, rattle and leak air exactly where your ducting meets a fan or filter. Fast Clamps replace that bodge with a rigid, foam-lined band that grips the spigot tightly and holds the join through a full cycle. The inner foam padding stops fan vibration transmitting down the ducting, so the low hum that gives an extraction system away doesn't travel along the line and joints don't work loose. Sizes run from 4 inch to 12 inch to match standard fans, carbon filters, silencers and rigid ducting.

Key Benefits

• Foam-lined band absorbs fan vibration so noise isn't carried through the ducting
• Secure clamping band grips far tighter than tape or cable ties and won't creep loose over a grow
• Sizes 4in to 12in to fit fans, carbon filters, silencers and rigid ducting
• Reusable fitting - unclip to service or swap kit, then refit without buying consumables
• Air-tight seal keeps your extraction pulling at full rate instead of leaking at the joins

How to Use

• Match the clamp size to your duct diameter, anywhere from 4in to 12in
• Butt the two parts together, such as a fan and carbon filter, and slide the clamp over the join
• Tighten the band until the foam lining sits snug against the duct
• Re-check the tension every few weeks as the ducting settles in