Omega Infinity 1000W 3.0 Pro LED

Full-spectrum output built for dense, even canopies

The Omega Infinity 1000W 3.0 Pro is an LED fixture for growers stepping up from starter panels or moving off HPS. Ten separate LED bars in a spider layout spread light edge to edge across a roughly 1.5m x 1.5m footprint, so the corners of the canopy get close to the same intensity as the centre. It draws 1,000W and puts out 3,099 umol/s of PPF at 3.0 umol/J efficacy, delivering genuinely high light levels without the heat load of an equivalent HPS.

Key Benefits

• 3,099 umol/s PPF at 3.0 umol/J for high, efficient light output measured properly rather than by headline wattage alone
• Ten-bar spider design spreads light evenly and reduces shaded corners across the canopy
• 1.5m x 1.5m coverage (up to 1.8m at lower intensity) to fill a standard grow space
• 25% dimming steps to tune intensity through veg, stretch and late flower
• Passive cooling, no fans so it runs silently with nothing to wear out or clog
• 60,000-hour diode life, UKCA, RoHS and CE certified

Leggy stretch and thin, airy buds under weak or ageing lighting?

Tired fluorescent panels, a worn HPS bulb or an undersized LED are common causes of stretch, low yields and buds that never fill out, because the plant is chasing light intensity that isn't there. The Infinity runs a full spectrum that keeps nodes tight through veg and drives bud set and density through flower, backed by 3,099 umol/s of measured output.

How to Use

• Hang the fixture above the canopy on the supplied hangers, higher during seedling and early veg
• Lower it gradually as plants establish and light tolerance builds
• Run around 25-50% for young plants, stepping up toward 100% as the canopy fills and through flower
• Link multiple fixtures with the Omega Matrix controller for grouped dimming and sunrise/sunset ramping
• Keep the driver area within your normal tent airflow