Description
Step a 1" Tap Down to a 3/4" Irrigation Fitting
The Antelco Tap Adaptor 1" BSPF x 3/4" BSPM screws onto a 1" BSP male tap, valve or outlet and gives you a 3/4" BSP male thread to take the standard 3/4" fittings used across drip irrigation: nut and tails, hose connectors, filters, timers and pressure regulators. A sealing washer sits inside the female end so it seals hand tight, and the body is moulded from UV stabilised plastic for long life outdoors or in the grow room.
Key Benefits
- 1" to 3/4" in one piece - no stacking of brass reducers or tape-wrapped threads.
- Washer included - seals against the tap face without PTFE tape.
- Hand tight - a ribbed grip body means no spanner is needed.
- UV stabilised - will not go brittle on an outside tap.
- Standard BSP threads - pairs with Antelco nut and tails and most 3/4" irrigation fittings.
Larger taps, water butt outlets and some valves carry a 1" thread, while most irrigation kit is built around 3/4". Without the right adaptor the joint leaks under pressure or needs a fiddly pile of fittings. This one reducing piece makes the change cleanly and keeps the supply end of your watering system tight.
How to Use
- Check the washer is seated inside the 1" female end.
- Screw the adaptor onto the 1" male thread hand tight.
- Fit your 3/4" female fitting (nut and tail, hose connector, filter or timer) onto the 3/4" male end.
- Turn the water on slowly and check both joints for drips.
Technical Specifications
- Brand: Antelco
- Inlet: 1" BSP female, with sealing washer
- Outlet: 3/4" BSP male
- Material: UV stabilised plastic
- Adaptors included: 25
