Description
Hold Your Grow Room Temperature Without Touching the Fan
The Super-Pro Air-Pro T-Series Fan Controller is a 5-speed stepped fan speed controller with digital temperature sensing. Set the temperature you want, a minimum and a maximum fan speed, and the on-board electronics step your inline duct fan up and down between them to keep the room there. A heavy-duty 5-step control stage keeps the fan quiet, without the buzzing and humming that cheap dimmer-type controllers can cause. Three models cover everything from a single tent fan to a large extraction set-up: T1 (4A), T2 (8A) and T3 (16A).
Key Benefits
- Automatic temperature control – fan speed rises as the room warms and drops back as it cools.
- Minimum and maximum speed limits – the fan never stops pulling air, and never runs harder than you allow.
- PRO night function – a photocell detects lights-off and gives the fan an extra step for 7 minutes every hour to clear humid air.
- Quiet 5-step control – no motor hum from the controller.
- Two sockets on the unit – plug in and run extraction straight away.
- Three load ratings – 900W, 1800W or 3600W total fan load.
Heat Spikes and Damp Nights
A fan running flat out all day is noisy and pulls warm air through the tent faster than it needs to, while one set too low lets temperature climb every time the lights come on. At night the opposite problem appears: the room cools, the fan slows, and humidity builds around the canopy. The Air-Pro answers both – it tracks the temperature through the light period and, with the PRO function on, pushes out damp air in short bursts through the dark period.
How to Use
- Place the temperature sensor in the room, out of direct airflow and not directly under a light.
- Point the photocell sensor at the light source. Leave its cap on unless you want the PRO night function.
- Plug the fans into the controller’s sockets, then set minimum speed (dial 1), target temperature (dial 2) and maximum speed (dial 3).
- Connect the controller to the mains. If the minimum is set at or above the maximum, the fan runs at the maximum; with no sensor connected it runs at the minimum.
- To switch the PRO function off again, unplug the controller, refit the photocell cap and plug back in.
Technical Specifications
- Control: 5-speed stepped, digital temperature sensing
- T1: 4A, 900W maximum load
- T2: 8A, 1800W maximum load
- T3: 16A, 3600W maximum load
- Dials: minimum speed, target temperature, maximum speed
- Sensor: combined temperature and photocell (light) sensor
- PRO function: one speed step higher for 7 minutes every hour in the dark
- Outlets: 2 x UK sockets
- In the box: controller, fuse, temperature and photocell sensor, 6 screws, 6 wall plugs
- Weight: 1kg
