Trolmaster Aqua-X Water detector (WD-2)

Catch a leak the moment it starts, before it floods the grow room

The TrolMaster Aqua-X WD-2 Water Detector gives early leak detection for grow rooms and hydroponic systems, alerting you the instant water reaches the sensor pad. A dripping reservoir, failing pump or split pipe in an automated setup can go unnoticed for hours and wreck electrical gear, so the WD-2 wires straight into a Hydro-X controller and triggers an alert before a slow drip becomes a serious flood. Multiple detectors can run from one control system for full coverage.

What's Included

• WD-2 Water Detector
• Touch Spot sensor pad
• RJ12 T-splitter
• 16ft RJ12 cable

Key Benefits

• Leak and flood detection for grow rooms, reservoirs and irrigation lines
• Direct Hydro-X integration with the TrolMaster environmental control system
• Instant alerts the moment water touches the monitored pad
• Multiple detector support from a single controller via the T-splitter
• Plug-and-play RJ12 connectivity for fast, tool-free installation
• Protects equipment and keeps automated irrigation running reliably through veg and flower

Leaks that go unnoticed for hours in automated irrigation

In an automated grow room, a leak from a reservoir, pump or plumbing joint can run undetected for hours or days, damaging electrical equipment and disrupting feed cycles before anyone spots it. The WD-2 detects water as soon as it reaches the sensor pad and has the Hydro-X system send an alert straight away, so you can act before the problem escalates and conditions stay stable across the whole cycle.

How to Use

1. Connect the WD-2 to the Hydro-X controller using the supplied RJ12 cable.
2. Place the Touch Spot sensor pad on the floor near likely leak points such as reservoirs, pumps or irrigation lines.
3. Use the RJ12 T-splitter if connecting several sensors within one system.
4. Power on the controller and confirm the sensor is recognised.
5. If water is detected, the Hydro-X system automatically sends an alert to notify you.