TrolMaster - ECS2 RJ12 to 3.5 Jack Extension Cable Set

Wire pigtail LED drivers straight into your Hydro-X system

The TrolMaster ECS-2 RJ12 to 3.5mm Jack Extension Cable Set bridges LED drivers that use loose pigtail control wires to the Hydro-X lighting control system - exactly the drivers that normally have no clean way to reach a controller. Its screw terminal block lands those bare control wires securely, so fixtures can be dimmed and scheduled from the same controller running your climate, holding consistent PPFD across the canopy through veg and flower.

What's Included

• 1 x 16 ft RJ12 cable
• 1 x RJ12 Y-splitter
• 1 x 4 ft RJ12 to 3.5mm jack cable with two-screw terminal block connector

Key Benefits

• Terminal block connector for LED drivers with pigtail or loose control wiring
• 0-10V dimming compatibility with a wide range of LED fixtures
• Daisy-chain wiring to bring multiple lights onto one Hydro-X network
• Centralised control of schedules and intensity alongside climate settings
• No-solder install using simple screw terminals

Turning loose driver leads into controllable, synced lighting

Many LED drivers ship with loose control wires that will not plug into a lighting controller, making it hard to automate intensity or sync lights with environmental controls. The ECS-2 provides a clean interface: the terminal block secures the driver's control wires while the RJ12 link ties the fixture into the Hydro-X network for balanced, uniform light across the room.

How to Use

1. Connect the 16 ft RJ12 cable to the Hydro-X lighting control adapter.
2. Fit the RJ12 Y-splitter if more than one lighting connection is needed.
3. Run the 4 ft RJ12 to 3.5mm cable to the LED driver's control port.
4. Land the driver's loose control wires on the two-screw terminal block.
5. Daisy-chain further fixtures if required.
6. Set dimming levels and schedules through the Hydro-X controller.