Shogun Samurai Hydro Bloom SW A&B – Soft Water Feed

Shogun's two-part bloom base, balanced for soft water

Shogun Samurai Hydro Bloom SW A&B is the soft water version of Shogun's two-part hydroponic base nutrient for the flowering stage. Soft tap water and reverse osmosis water carry little calcium or magnesium, so this formulation supplies them alongside the full macro and micronutrient balance. Shogun's SmartZen technology is built in to lift photosynthesis and nutrient transport, and the feed works in both recirculating and run-to-waste systems and with the rest of the Shogun additive range.

Key Benefits

• Soft water formulation for soft tap supplies and RO water
• Complete two-part bloom feed - Part A NPK 2.7-0-0, Part B NPK 1-3.2-5.3
• SmartZen technology - Shogun quote up to 8% higher yield than a baseline NPK feed
• Flower and fruit development driven by the P and K weighting of Part B
• Works with every hydro system, recirculating or run-to-waste
• Fully compatible with Shogun's boosters and supplements

Deficiencies from the wrong feed for your water

A hard-water bloom nutrient assumes the tap is already supplying calcium and magnesium. On soft or RO water that leaves the solution short just as flowering demand peaks, showing as poor nutrient uptake, leaf-edge scorch and weak flowering. The SW version corrects for that starting point, so the reservoir is balanced from the first dose.

How to Use

• Use Grow A&B or Bloom A&B, never both in the same solution.
• Fill the reservoir with a measured amount of water and shake both bottles.
• Add Part A at 2-3 ml/L and stir thoroughly, then Part B at 2-3 ml/L and stir again. Never mix the concentrates together undiluted.
• Add any Shogun additives after the base is mixed, then set pH 5.5-6.5 and check EC against the Shogun feed chart.
• Refresh the solution every 7-14 days in recirculating systems.