BioGreen Soil Feed Chart – Grow 1 and Bloom 2 Doses

BioGreen's own published Soil, Grow 1 and Bloom 2 schedule. If your base feed is one bottle marked Grow 1 for veg and a second marked Bloom 2 for flower, this is your chart — if it is two bottles marked Part A and Part B, you want the Soil A&B chart. Week by week, in millilitres per one litre of water.

BioGreen soil feed chartSoil · rooting to plain water · tap to enlarge
BioGreen soil feed chart – Grow 1 and Bloom 2 doses per litre, rooting to flush
  • All dosesper 1 litre
  • pH5.8 – 6.2
  • Base feedGrow 1 to 1.5ml, then Bloom 2 to 2ml

Every figure is millilitres per one litre of water. Multiply by ten for a 10-litre watering can — so 1.75ml here is 17.5ml in a full 10-litre can. A dash means the bottle is not used that week.

Getting it right

  • Grow 1 and Bloom 2 overlap for exactly one week. Flower 1 is the changeover: 1.25ml of Grow 1 and 0.25ml of Bloom 2 in the same can. After that Grow 1 stops for good and Bloom 2 takes over on its own.
  • These are per-litre doses, not per ten litres. Read the figure, then multiply by the number of litres you are mixing. Several of them are quarter-millilitres, so a syringe beats a measuring cap.
  • Calgel has a weekly dose on this chart. That is the clearest difference from BioGreen's other soil schedule, where Calgel carries no figure at all. Here it runs from 0.25ml at Grow 1 up to 0.4ml at Flower 6, then back to 0.3ml from Flower 7 to Flower 9.
  • PK 13/14 and X-Blast are not run together. BioGreen print that instruction on the chart: PK 13/14 at Flower 3 and Flower 4, X-Blast from Flower 5 onwards. Both appear against the later columns of the grid, so pick one.
  • The boosters are dosed lower here than on the A&B soil chart. PK 13/14 peaks at 1ml and X-Blast at 1ml on this schedule; on the Soil A&B chart both peak at 1.5ml. Do not carry figures across between the two.
  • X-Force is measured in fractions of a millilitre. 0.1ml from Cutting 1 to Grow 4, 0.15ml from Flower 1 to Flower 9. That is 1ml and 1.5ml in a 10-litre can.
  • pH moves once, part way through flowering. BioGreen print 5.8–6.0 from Cutting 1 to Flower 4, then 6.0–6.2 from Flower 5 to the final plain-water week.
  • This chart has no EC row. BioGreen give EC targets on their coco, hydro and Soil A&B charts but not on this one, so go by the millilitre figures and the pH.
  • The plain-water week is not an empty one. Calgel, Bloom 2, X-Rooting, PK 13/14, X-Blast, X-Force and Garlic all stop. Biozym goes in at 3ml and X-Bloom at 2ml.

Everything on the chart

Common questions

How do I know this is my chart and not the other BioGreen soil one?

Look at the base feed. One bottle labelled Grow 1 for veg and a second labelled Bloom 2 for flower means this chart. Two bottles labelled Part A and Part B, dosed together at the same rate, means the Soil A&B chart. The additive doses differ between the two, so it matters.

Do I really run Grow 1 and Bloom 2 in the same can?

For one week only. Flower 1 carries 1.25ml of Grow 1 and 0.25ml of Bloom 2. From Flower 2 onwards Grow 1 is finished and Bloom 2 runs on its own at 1.5ml, rising to 2ml.

Why does Calgel have a dose here but not on the A&B charts?

That is how BioGreen print them. This soil chart gives Calgel a figure for every week from Grow 1 to Flower 9. The coco, hydro and Soil A&B charts replace it with a rule instead: bring soft water up to EC 0.6 with Calgel before feeding.

What pH should I be at?

5.8 to 6.0 from Cutting 1 through to Flower 4, then 6.0 to 6.2 from Flower 5 to the final plain-water week. Check it after everything is mixed.

Where are the EC targets?

This chart does not have them. BioGreen publish EC by week on their coco, hydro and Soil A&B charts, but the Grow 1 and Bloom 2 soil chart carries only pH.

Shop the full BioGreen range

Figures as published by BioGreen on their own soil feeding chart, biogreenuk.com. Always read the label on the bottle you own. BioGreen is a trade mark of its owner.

Back to blog